1. Clean the dust and debris of all parts of the CNC Plasma Cutting Machine, and use the dry air pipe to clean the dust and dirt inside and outside the cabinet; 2. Fill the longitudinal guide rail and the linear slide rail with lubricating oil, check whether the walking mechanism and the lifting body are stable and accurate. If it is not accurate, check the adjustment of the vertical and horizontal moving rack without gap clamping device, and adjust the rail guide bearing to the rail clamp. Tight force 3. Check the pipe joint, the sealing of the valve body, and whether the gas pipeline leaks; 4. Check if the water level of the cooling water is suitable;
5. Discharge water to the gas storage tank before work every day, because there is air pressure inside the gas storage tank during off-hours, the water discharge speed is relatively fast, and it is put relatively thoroughly;
6. Regularly check whether the electronic drainer pipe of the Cnc Plasma Cutting Machine is blocked;
7. Check the operation of each electric control cabinet filter and cooling fan;
8, check the machine operating keyboard and LCD screen is normal
9. At this point, you can start a new day's work.
It should be noted that if the longitudinal rails or guide rails are too dirty, the diesel oil can be cleaned first and then oiled; if there are two shifts or three shifts, the operation will be carried out once a day, and the white shift staff will be responsible.
