As a product with high cutting precision and high speed, Buluoer CNC plasma operation procedures have always been a concern of users. So, what are the precautions in the operation? Blol is a high-tech enterprise specializing in R&D and manufacturing of CNC equipment. I. The operator should be familiar with the performance and technical parameters of the equipment. Read the equipment instruction manual and system operation manual carefully before use, and follow the operating procedures of the equipment CNC Plasma Cutting Machine. After passing the examination, the operation permit will be operated on the machine. 
II. The precautions before the official operation 1. It is strictly forbidden to place inflammable and explosive materials on the guide rail and working surface of the Cutting Machine, and to clean and lubricate the rails, gears and racks. 2. Check the plasma consumables and replace them if they are damaged. 3. After the new cutting program is input, the machine should be tested first and confirmed to be correct before being put into operation. 4. After opening the air supply main valve, adjust the air outlet pressure according to the number of torches to be used, check whether the safety device is effective, whether the air supply pipeline is allowed to leak, and find the problem in time. 5. When cutting components with elements such as zinc, aluminum, cadmium, etc., the operator should standardize the helmet that wears the breathing apparatus or air supply, or ensure that the generated fumes can be removed in time. Buluoer Cnc Plasma Cutting Machine
III. The operation notes after the machine 1. Observe the operation of the equipment in time during the cutting process, and replace the electrodes and nozzles in time to prevent damage to the machine. If the material is not cut through, stop the equipment and adjust the speed of the equipment to achieve the best cutting results. 2. When the equipment is running, the operator must not leave the post, pay attention to observe the operation of the equipment, so as not to go out of the effective range or collision. 3. The cutting material should be placed parallel to the guide rails, and the flame of each torch should be adjusted to be approximately the same, so that the cutting effect is good. 4. Do not touch any buttons with wet hands. Do not touch equipment, torches, or workpieces while cutting to prevent electric shock. 5. Timely removal of dust, waste residue, etc. on the cutting table has ensured the normal operation of the equipment. IV. The precautions after the equipment is stopped 1. After cutting, the power and air supply should be turned off in time. 2. Clean the corners, cutting slag and other debris on the cutting table and the guide rails, keep them clean, and achieve good cutting results when using them next time. 3. Wipe the rail and lubricate the rail surface and the rack. 4. The shutdown sequence is: servo power - controller cancel key is returned to the main interface - controller power switch - variable power - total power switch. Buluoer CNC Plasma Cutting Machine cutting sample As long as the equipment is carefully maintained according to the above-mentioned operating rules of CNC plasma cutting machine, and the daily standard operation, the service life of the cutting machine will be prolonged, and the cutting effect will meet the requirements. Finally, don't forget that when replacing consumable parts such as cutting nozzles, be sure not to turn off the plasma power supply to prevent electric shock and prevent coolant loss.
